Add Virtual Network Adapter Windows 11 Link |best| Jun 2026

There are several distinct types of virtual network adapters available in Windows 11:

His eyes locked onto the target: .

Right-click the Start menu and select or PowerShell (Admin) . Step 2: Run the Creation Command

Ensure the Virtual Switch was applied correctly and the Hyper-V Networking service is running.

On the left pane, select . On the right pane, scroll until you find Microsoft KM-TEST Loopback Adapter . add virtual network adapter windows 11 link

Click Next through the confirmation prompts to complete the installation.

Click to confirm, then click Next again to start the installation. Click Finish . Method 2: Use Hyper-V Manager (For Virtual Machines)

: Go to Control Panel → Network and Sharing Center → Change adapter settings → right‑click your physical adapter → Properties → Sharing tab, and uncheck “Allow other network users to connect through this computer‘s Internet connection”.

: Run Add-VMNetworkAdapter -VMName "YourVMName" -SwitchName "YourSwitchName" . Troubleshooting Common Issues Create and configure a virtual switch with Hyper-V There are several distinct types of virtual network

If you use Windows Subsystem for Linux 2 (WSL2), Windows 11 automatically creates a virtual adapter. It‘s a NAT‑based adapter that connects your Linux distribution to the network through your host. To check if it‘s present:

The quickest way to start is not navigating menus, but using a direct command. Press Windows + R to open the Run dialog box. Type the following command and press Enter:

Use Radmin VPN or Hamachi to install virtual adapters on multiple computers across the internet. Once installed, these computers see each other as if they‘re on the same physical switch, enabling LAN gaming, file sharing, and collaborative development.

Bridges to your physical NIC, allowing VMs to access your actual network/internet. On the left pane, select

Replace "Ethernet 2" with the exact name of your virtual adapter (you can see the name in ncpa.cpl ) and the IP/subnet with your preferred values. For DHCP assignment:

After you have added a virtual network adapter (e.g., the KM‑TEST loopback adapter), you usually need to assign it an IP address. You can do this through the graphical interface or the command line.

Enable-WindowsOptionalFeature -Online -FeatureName Microsoft-Hyper-V-All

This feature would position Windows 11 as the most network‑flexible desktop OS, competing with Linux tun/tap and macOS virtual interfaces.

An external switch bridges virtual machines directly to the physical network. VMs get their own IP addresses on the same subnet as your host, just like physical computers on your LAN.