Rok Power Washer Instructions New -

Pull back the quick-connect brass collar at the end of the lance.

Once a steady, continuous stream of low-pressure water flows out of the nozzle without sputtering, release the trigger.

To ensure your machine operates safely and lasts for years, it is crucial to follow the correct setup and operating procedures. This article provides comprehensive, step-by-step instructions for your new ROK power washer, covering everything from unboxing to maintenance. 1. Unboxing and Initial Assembly rok power washer instructions new

Before you connect a hose or plug into an outlet, lay out all the components on a flat surface. Your ROK power washer box should contain the following:

Before turning on the power, turn on the water supply fully. Squeeze the trigger on the spray gun without the machine being on. Let the water run through the gun until a steady stream comes out. This removes air from the pump, preventing "cavitation". 3. Operating Instructions for New Units Once the setup is complete, it is time to start cleaning. Turn on Water: Ensure the water supply is turned fully on. Pull back the quick-connect brass collar at the

. While user manuals can sometimes be misplaced, the setup and operation follow a standard procedure common to most electric and petrol pressure washers [14]. 1. Assembly & Initial Setup

Pull back the collar on the spray wand and insert the desired nozzle tip, then release the collar to lock it into place. Your ROK power washer box should contain the

Mix your pressure-washer-approved detergent according to the bottle instructions. Never use household bleach or thick dish soaps, as they will corrode internal pump components.

If using detergent, flush the system with clean water for 1-2 minutes.

New ROK petrol power washers are shipped without oil in the engine crankcase. Locate the yellow dipstick at the base of the engine. Add the manufacturer-recommended oil (typically SAE 10W-30) until it reaches the full mark on the dipstick. Do not overfill.