This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
: Navigate to the Dockside Settings menu to perform the "Rudder Feedback Calibration" and "Rudder Test" to verify the system sees the live changing values as the helm is turned.
, a software-based approach that eliminates the need for a physical sensor altogether. 🛠️ Official Resources simrad rf300 installation manual
center to its ball joint (Y2). This ensures a 1:1 mechanical relationship. Wiring & Connections : The
This paper provides a comprehensive technical guide for the installation, configuration, and maintenance of the Simrad RF300 Rudder Feedback Unit. As a critical component in modern autopilot systems, the RF300 provides essential data regarding rudder position, enabling accurate course-keeping and maneuverability. This document outlines the necessary tools, mounting procedures, electrical interfacing, and calibration steps required to ensure optimal performance. Special attention is given to mechanical alignment and compatibility with Simrad autopilot computers. This public link is valid for 7 days
Your vessel's (hydraulic helm, linear mechanical drive, or rotary chain).
Turn the helm fully to port until it hits the mechanical stop. Press confirm. Can’t copy the link right now
Enter the by pressing and holding the STBY or MENU key for 5 seconds (depending on your specific control unit model).
|
1999/2009
© This site is maintained and constantly updated by Robert
Schwandl
|