If you are outside the four standard US time zones or the signal is weak, you can set the time manually: Enter Manual Mode : Press and hold the (or manual flap) button for 3+ seconds. Adjust Time : Once in manual mode, hold the
Stop pressing buttons. The clock will begin ticking normally from that point and will still attempt an atomic sync overnight. For Digital Kincaid Clocks
Before you start using your Kincaid radio controlled clock, make sure you have the following items: kincaid radio controlled clock instruction manual
The single most common cause of sync failure is low battery voltage. Even if a battery can power a digital screen or move analogue hands, it may lack the power required to drive the internal radio receiver module. Replace old batteries with a fresh pair of premium brand alkaline batteries.
The hour digits will begin to flash. Use the UP/DOWN or ADJUST buttons to change the hour. Press SET again to move to minutes, year, month, and date. If you are outside the four standard US
And that, however strange, is a kind of magic.
after setting. It will resume normal ticking and continue searching for the radio signal in the background. 4. Understanding the Signal Strength Indicator For Digital Kincaid Clocks Before you start using
, preferably one facing toward Fort Collins, Colorado.
: Use one fresh AA alkaline battery . Once inserted, the hands will usually spin to a preset position (often 12:00, 4:00, or 8:00) and stop while searching for the signal.
Leave the clock completely undisturbed. The synchronization process can take anywhere from 4 to 15 minutes . Once the WWVB atomic signal is successfully received, the clock will automatically adjust its hands or digital display to the correct local time. 2. Setting Your Local Time Zone
for 3 seconds until the year or hour display begins to flash.