Ts1162 Installation Manual [UPDATED]

If the TS1162 is the last device on a long RS-485 cable run, set the termination DIP switch (typically Switch 8) to the 'ON' position to prevent data signal reflections. 4. System Integration

Measure and mark a precise rectangular opening on your panel door or enclosure surface. (Refer to your specific TS1162 box for exact millimeter specs; standard controller cutouts are generally 71mm x 29mm).

This is often due to incorrect RS-485 wiring. Double-check the "A" and "B" communication leads for proper polarity. Ensure the total cable length from the panel to the farthest device on the RS-485 LAN does not exceed 1.5 km, and avoid routing the cable near high-voltage lines.

To help refine these instructions for your specific setup, could you share a bit more context? Let me know the of your TS1162, the specific industry or application it is used for (e.g., HVAC, security, or automotive), and if you need detailed software configuration steps . Share public link

:

Tecom TS1162 Installation Manual: Comprehensive Guide to Installing the 3 LED RAS Keypad The Tecom TS1162 Remote Arming Station (RAS)

Once the printer stops feeding and the LED turns solid , the calibration is successful. 6. Maintenance and Printhead Care

This guide provides a structured overview of the installation process based on typical Challenger LAN wiring practices and technical specifications. 1. Introduction to the TS1162 3 LED RAS The Tecom TS1162

Observe the LED indicators on the front panel of the TS1162. ts1162 installation manual

Includes a input and an open collector output for door relays.

Once hardware installation is complete, follow these configuration steps to initialize the device.

If any parts are missing or damaged, stop immediately and contact customer support. 3. Step-by-Step Mounting and Hardware Installation

The TS1162 must be addressed so the Challenger panel can recognize it. If the TS1162 is the last device on

Check the RS-485 LAN connections and ensure the DIP switch address does not conflict with another device.

For concrete/brick: Use masonry bits and insert the included wall anchors. Step 3: Secure the Bracket

Snap the front keypad assembly back onto the base. 3. Wiring and Connections