Bushnell 3-9x40eg Manual Online

Look through the scope and ensure the vertical crosshair aligns perfectly with the center mass of your rifle. A canted reticle causes horizontal errors at long distances.

Repeat this quick-glance process until the reticle is perfectly sharp the moment you look through the optic. Operating the Dual-Illumination (EG)

Tighten the ring screws evenly in a cross-pattern (like tightening lug nuts on a car tire). Do not over-tighten, as crushing the 1-inch tube will permanently damage the internal tracking components. If using a torque wrench, aim for 15–18 inch-pounds for the top rings. Step 2: Focusing the Reticle

A: Absolutely. The 3-9x40eg excels on a rimfire for small game. The parallax is fixed at 100 yards, which is suboptimal for 25-yard .22 shots, but for hunting squirrels at 50+ yards, it works fine. bushnell 3-9x40eg manual

Settings usually range from 1 to 5 or higher. Use the lowest setting possible to avoid glare, which can hide the target.

Located at the front, gathers light to project the image. 2. Mounting the Riflescope

At 100 yards, 4 clicks = 1 inch. At 50 yards, 8 clicks = 1 inch. Look through the scope and ensure the vertical

A canted (tilted) reticle causes horizontal errors at longer distances. Step 4: Torque the Screws Tighten the ring screws evenly in a cross-pattern.

Turn clockwise or counter-clockwise following the "UP" arrow direction to raise the point of bullet impact.

Insert one with the positive (+) side facing upward. Thread the cap back on securely. Adjusting Brightness Turn the dial to cycle through the illumination options. Operating the Dual-Illumination (EG) Tighten the ring screws

| Your bullet impact is... | Turn the windage turret... | Turn the elevation turret... | | :--- | :--- | :--- | | | Counter-Clockwise (Right) | Clockwise (Up) | | Low and Right | Clockwise (Left) | Clockwise (Up) | | High and Left | Counter-Clockwise (Right) | Counter-Clockwise (Down) | | High and Right | Clockwise (Left) | Counter-Clockwise (Down) |

If the target is clear but the crosshairs are blurry, readjust the ocular focus ring at the rear of the scope.