: Use the preset keys on the touch screen or enter the PLU number manually and press the PLU button.
Check if anything is touching the edges of the platter. Press the key. Label does not print Print head is open or sensor is dirty. digi sm5300b manual work
This report is a synthesized summary based on Digi’s standard documentation for similar SOM modules. For exact pinouts, connector part numbers, and safety certifications, refer to the official Digi SM5300B Hardware Reference Manual provided by Digi International. : Use the preset keys on the touch
| Problem | Likely Cause | Manual Fix | |--------|--------------|-------------| | Current reading shows negative when charging | Shunt sense wires reversed | Swap S+ and S- wires physically | | SOC jumps from 80% to 100% instantly | Charged voltage (P-04) set too low | Increase by 0.2V and repeat full charge | | SOC never reaches 100% | Tail current (P-05) too low | Increase to 5% or 8% for old batteries | | Display dim or blank | Aux power missing or low | Measure AUX input – must be 12-24V DC | | Erratic current readings | Loose shunt terminal bolts | Power off and torque bolts to spec (10 Nm) | Label does not print Print head is open or sensor is dirty
, you may need to manually perform a gap sensor calibration by holding specific key combinations during power-on to ensure the auto-cutter hits the mark every time. 2. The Rush: Fast PLU Call-Up
By following this guide and leveraging the resources provided, you'll be well on your way to becoming proficient in manual work with the Digi SM5300B. Whether you're a seasoned technician or just starting out, the rewards of manual work with this powerful device are well worth the effort.
: Periodically check the auto-cutter for adhesive buildup, especially when using linerless labels. 5. Troubleshooting Common Issues