Input your desired Receive (RX) and Transmit (TX) frequencies and tones. Write/Clone:
In the CS-F300 software, go to the "Setup" menu and choose the correct port.
Once you have the software installed and the cable connected, follow this procedure to program your radio.
If using Windows 10/11, right-click the executable file, go to , choose the Compatibility tab, and set it to run in compatibility mode for Windows XP (Service Pack 3). Launch the software. Icom Ic-f310 Programming Software
Assign functions to the programmable keys, such as Scan Tag, Monitor, or High/Low power.
Modern USB alternatives that integrate the converter into the cable shell are available at retailers like Unicom Radio and Latinafy . Key Specifications & Setup
Software alone is not enough to configure your IC-F310. You will need a specific hardware interface to connect your computer to the radio's microphone jack. 1. The Programming Cable Input your desired Receive (RX) and Transmit (TX)
Now you can edit the memory channels to match your licensed frequencies:
To help you get your transceiver up and running, let me know: What is your computer currently running?
disconnect the cable or turn off the radio while data is transferring. If using Windows 10/11, right-click the executable file,
Note the COM port number assigned to your cable (e.g., COM2). If it is higher than COM4, manually change it to COM1, COM2, COM3, or COM4 in the advanced properties, as legacy software rarely recognizes high port numbers. Step 3: Run the Software and Read the Radio
Double-check that the software settings match the actual assigned Windows COM port number. "Check Sum Error" This indicates corrupted data during transmission.
into the radio's microphone jack and connect the other end to your PC's serial port.
This comprehensive guide covers everything you need to know about acquiring, installing, and utilizing the Icom IC-F310 programming software to manage your radio fleet effectively. 🔑 Key Software Requirements and Compatibility
The IC-F310 utilizes the microphone jack on the front panel for data cloning. You will need: An (or compatible) programming cable.